Receipt printer not printing? Check these in order
Look at the lights first, then run the printer's self-test. If the test prints, the printer is fine and the problem is the cable, network or till.
It's Friday, the tickets stop, and the queue is growing. Before you restart everything, spend two minutes on these checks. They work in this order because each one rules out half the problem.
The button steps below are from Epson's manual for the TM-m30III. Most receipt printers work the same way. If yours is a different model, its own manual is on the product's Support tab.
1. Read the lights
- Error light on, not flashing: the printer is paused. The usual reasons are an open cover or no paper. Close the cover until it clicks and check the roll.
- Paper light on: the roll is nearly empty or finished. Put a new one in.
- Error light flashing: a real fault, such as a cutter jam. Turn the printer off, wait 10 seconds and turn it back on. If it still flashes, the printer needs a repair. Ask us.
- No lights at all: check the power lead is pushed in at the printer and at the wall.
2. Check the roll
Open the cover, take out the old core and put the new roll in the right way round. Pull a little paper out before you close the cover. Epson also says to pull any slack out of the roll first, because a loose roll jams.
Thermal paper only prints on one side. If tickets come out blank, the roll is in back to front.
3. Run the self-test
- Close the roll paper cover.
- Hold down the Feed button and turn the printer on. Keep holding until it starts printing.
- It prints its current settings, then a line telling you how to carry on, and the paper light flashes.
- Press Feed briefly (less than a second) to print the test pattern.
- When "*** completed ***" prints, the printer resets and goes back to normal.
If the self-test prints, the printer is fine. The fault is between the printer and your till.
4. When the self-test works but orders don't print
- USB printer: unplug the cable at both ends and plug it back in. Try another USB socket on the till.
- Network printer: the Ethernet or Wi-Fi light should be on, not flashing. Flashing means it is still getting an address from your router, so give it a minute. If the router was restarted, the printer may have a new address while the till still sends to the old one: check the address in the till's printer settings.
- On the till: check the printer you print to is still the one switched on in the till's printer settings.
Still stuck? Open the chat on this page with your order number ready and we'll go through it with you.